Lincoln Electric POWER MIG 180 DUAL Operator's Manual page 8

POWER MIG 180 DUAL
TECHNICAL SPECIFICATIONS - 180 AmP uNIT
(K3018-1)
INPUT – SINGLE PHASE ONLY
Standard Voltage/Frequency
230 V 60 Hz
208 V 60 Hz
120 V 60 Hz
RATED OUTPUT
Voltage/Duty Cycle Current
230 V 30% 130 Amps
208 V 30% 130 Amps
120 V 20% 90 Amps
OUTPUT
Welding Current Range
(208 V / 230 V) 30-180 Amps
(120 V) 30-140 Amps
RECOMMENDED INPUT CABLE AND FUSE SIZES
Fuse or
Input Voltage /
Breaker
Frequence
Size
230 V / 208 V 60 Hz 40 Amp
120 V 60 Hz 20 Amp
PHYSICAL DIMENSIONS
Height Width
14.08 in. 10.37 in.
(357.6 mm) (263.4 mm)
1 If connected to a circuit protected by fuses use Time Delay Fuse
marked "D".
2 Requirements for maximum output: In order to utilize the maximum output
capability of the machine, a branch circuit capable of 30 amps @ 120
volts, 60Hz is required.
Input Current
20 Amps @ rated output
Voltage at Rated Amperes
20
17.6
19.5
Open Circuit
Wire Speed Range
Voltage
34 V 50 - 500 in/min.
33 V (1.3 - 12.7 m/min.)
Input (Power Cord) Lincoln
Amps Electric Part Number
1
20 M22590
2 20 M22589
Depth Weight
18.78 in. 66 lbs.
(477.6 mm) (30 kg.)
Read this entire installation section before you
start installation.
INST LL TION
WARNING
ELECTRIC SHOCK CAN KILL.
• Only qualified personnel should perform
this installation.
• Only personnel that have read and
understood the POWER MIG 180 DUAL
Operator's Manual should install and
operate this equipment.
• Machine must be plugged into a receptacle which is
grounded per any national, local or other applicable
electrical codes.
• The POWER MIG 180 DUAL power switch is to be in the
OFF ("O") position when installing work cable and gun and
when connecting power cord to input power.
SELECT SuITABLE LOCATION
Locate the POWER MIG 180 Dual in a dry location where there is
free circulation of clean air into the louvers in the back and out the
front of the unit. A location that minimizes the amount of smoke
and dirt drawn into the rear louvers reduces the chance of dirt
accumulation that can block air passages and cause overheating.
STACKING
POWER MIG 180 DUAL cannot be stacked.
TILTING
Each machine must be placed on a secure, level surface, directly
or on recommended cart. The machine may topple over if this
procedure is not followed.
A-1
INSTALLATION