DieHard 28.71239 Operator's Manual page 9

BATTERY CLAMP QUICK-CONNECT
1. Connect the end of the charger output cable to the end of the battery
clamp quick-connect.
2. Follow the steps in previous sections to connect the output clamps
to the battery.
3. After a good electrical connection is made to the battery, plug the power
cord into a grounded 120V AC electrical wall outlet.
RING TERMINAL QUICK-CONNECT
The ring connectors permanently attach to the battery, providing easy access
to quickly connect the charger to your battery. This application is appropriate
for motorcycles, lawn tractors, ATVs and snowmobiles.
1. To permanently attach to a battery, loosen and remove each nut from the
bolt at the battery terminal.
2. Connect the red POSITIVE connector ring to the POSITIVE battery terminal.
3. Connect the black NEGATIVE connector ring to the NEGATIVE battery
terminal.
4. Replace and tighten the nuts to secure.
5. Connect the cable to the end of the charger output cord.
Take care to keep the wires and plug away from metal and moving parts.
6. Plug the charger power cord into a grounded 120V AC electrical wall outlet.
12V ACCESSORY PLUG QUICK-CONNECT
Charge or maintain your battery without lifting the hood.
1. Connect the end of the 12V Accessory Plug quick-connect to the charger.
2. Insert the 12V accessory plug into the 12V accessory outlet.
3. Route the power cord from the charger through the vehicle's open window.
4. Plug the charger power cord into a grounded 120V AC electrical wall outlet.
5. If the vehicle's ignition key has to be on in order for the accessory outlet
to supply/receive power, turn the key, without starting the engine.
AUTOMATIC CHARGING MODE
When an automatic charge is performed, the charger switches to the maintain
mode automatically after the battery is charged.
BATTERY CONNECTION INDICATOR
If the charger does not detect a properly connected battery, charging will not
start and the digital display will show one of two messages. If the display
shows CONNECT CLAMPS, make sure the charger is connected to the
battery and the connection points are clean and making a good connection.
If the display shows WARNING CLAMPS REVERSED, unplug the charger
from the AC outlet, reverse the connections at the battery, and then plug the
charger back in.
• 9 •