Table of Contents
Advertisement
2.3 Chassis Components
Installing the Storage Drive
The SC101iF can accommodate a single fixed 2.5" storage drive up to 9.5 mm thickness. It
is installed to a mounting tray inside the chassis. Note: Enterprise level hard disk drives are
recommended for use in Supermicro chassis and servers.
Installing the Hard Drive
The motherboard should be installed before installing the drive.
1. Make sure there is no power to the system as described in section 2.1 and remove the
chassis cover.
2. Remove the screws securing the hard drive tray to the support bracket and set them
aside for later use. Lift the tray out.
Chapter 2 Maintenance and Component Installation
Figure 2-2. Removing the Drive Tray
13
Advertisement
Table of Contents
