Invacare Bora XTR Service Manual page 10

Invacare® Bora® / Spectra® XTR Series
1. Remove seat plate or sling seat (1). See Modulite
service manual, "Adjusting seat width/backrest width"
chapter.
2. Loosen screws (2) in front and rear, left and right –
DO NOT remove.
3. Shift position of seat.
4. Re-tighten screws.
5. Install seat plate or sling seat.
One-Piece Seat Plate
• 6 mm Allen key
Fig. 4-7 This picture is an example.
Seat Depth Setting
Adjust the seat depth using the profile scale (1) in accordance with the following table:
10
Fig. 4-6
1. Remove seat plate (1) or sling seat. See Modulite
service manual, "Adjusting seat width/backrest width"
chapter.
2. Loosen Allen screws (2) in front and rear, left and right
– DO NOT remove.
3. Shift position of seat frame.
4. Re-tighten screws.
5. Install seat plate again.
Mounting Position of Seat Frame
The centre of gravity of the seat can be adjusted by
mounting the seat frame farther towards the front or the
rear on the seat support. See Modulite service manual.
If the mobility device is used with drive lock-out, choose
different screw positions, for example:
Fig. 4-8 Mounting Position of Seat Frame with Flex3 Backrest and
Fig. 4-9 Mounting Position of Seat Frame on Seat Support Without
Fig. 4-10
Seat Depth 51 cm
Drive Lock-Out
1528338-Q