Electronic/Switch Setting - Smeg BL1S Instruction Manual

User instructions
ELECTRONIC SETTING
The value entered for this parameter establishes whether or not regeneration is to be carried out
at the end of the washing cycle, on the basis of the table below.
SETTING
0
1
2
3
4
5
Contact your local water board for information on the hardness of your water supply.
N.B.: a cycle is a washing program.
Programming procedure:
Press the PROGRAM SELECTION (2) and DELAYED START (3) buttons simultaneously for
•
3 seconds until the DISPLAY (7) shows the symbol "H";
Press the DELAYED START button (3) to modify the parameter;
•
Press the PROGRAM SELECTION button (2) to exit from the procedure.
•
SWITCH SETTING
According to the machine model, the selector which acts on the adjustment may be located:
inside the plastic locking ring located on the right-hand side, inside the dishwasher;
•
inside the water softener, just below the cap.
•
Both allow for adjustment to 5 settings:
WATER HARDNESS
< 9°dH (15°dF)
< 15°dH (25°dF)
< 23°dH (40°dF)
< 34°dH (60°dF)
< 46°dH (80°dF)
< 58°dH (100°dF)
REGENERATION
Not performed
Performed every 5 cycles
Performed every 4 cycles
Performed every 3 cycles
Performed every 2 cycles
Performed every cycle
35