Using the Belkin Wireless Access Point Manager
Changing the Password
1. Select "Configure", then
"Change Password".
2. Enter the new password, then
confirm it. Press "OK".
After changing the password, you will need to connect to the AP again.
Resetting the WAP
If the WAP stops working properly, performing a reset can solve the problem.
From the main screen, select "Configure", then "Reset AP". The AP will reset
itself. After resetting, you will need to connect to the AP again.
Restoring Factory Default Settings
To restore the factory default settings, select "Configure", then "Reload Default".
The AP default settings will be restored. After restoring the defaults, you will
need to connect to the AP again.
WAP Parameter
AP Name
SSID
Channel
RTS Threshold
IP Address
Subnet Mask
Default Gateway
DHCP Client
Encryption
MAC Address Filter
Password
Default Value
MiniAP
WLAN
11
2346
192.168.0.254
255.255.255.0
0.0.0.0
Enabled
Disabled
Disabled
MiniAP (case-sensitive)
21