Table of Contents
Advertisement
Installing the Switch Chassis
b) Position a slider rail at the desired level on the back side of the rack and use 12-24 screws or 10-32 screws, depending
on the rack thread type, to attach the rails to the rack (see the following figure). Tighten 12-24 screws to 30 in-lb
(3.39 N·m) of torque and tighten 10-32 screws to 20 in-lb (2.26 N·m) of torque.
c) Repeat Step 3 to attach the other slider rail to the other side of the rack.
To make sure that the slider rails are at the same level, you should use a level tool, tape measure, or carefully count
the screw holes in the vertical mounting rails.
Step 4
Insert the switch into the rack and attach it as follows:
a) Holding the switch with both hands, position the two rear rack-mount brackets on the switch between the rack or
cabinet posts that do not have slider rails attached to them (see the following figure).
b) Align the two rear rack-mount guides on either side of the switch with the slider rails installed in the rack. Slide the
rack-mount guides onto the slider rails, and then gently slide the switch all the way into the rack until the front
rack-mount brackets come in contact with two rack or cabinet posts.
Installing the Switch using the NXK-ACC-KIT-1RU Rack-mount Kit
Cisco Nexus 9236C NX-OS Mode Switch Hardware Installation Guide
19
Advertisement
Table of Contents
