2.2 Integral Mounting
Table 2-2 Integral Mounting Procedure for ORP Electrodes
Step
Connect Electrode to Pipe and Electronics Assembly (Figure 2-3)
1
Screw the electrode into the pipe tee (3/4 " NPT thread).
Make sure that the final position of the installed electronics module allows the display to
be easily viewed by plant personnel.
2
Align the slots in the electronics module with those in the electrode and press down to
connect the electronics to the electrode.
3
Tighten the locking screw on the bottom rear of the electronics module.
1/03
Step 2
Step 3
Figure 2-3 Integral Mounting
DirectLine® DL422 Sensor Module User Manual
Procedure
Electronics
Module
Locking Screw in
Rear of Housing
Step 4
Electrode
Step 1
Installation
7