HEIDENHAIN IK 5000 QUADRA-CHEK Installation Instruction page 18

IK 5000 QUADRA-CHEK
Installation Instructions
Operating Instructions available at www.heidenhain.de
4. Installation
Read and understand the OEM system manufacturer Operating Instruction and
the PC manufacturer Operating Instruction before beginning the installation to
avoid the possibility of personal injury or death.
The safety of any system incorporating the use of this product is the
responsibility of the assembler or installer of the system.
Notice
Do not engage, or disengage any connections while the unit is under power.
Damage to internal components may result.
Interfaces
Interface connections
X,Y and Z Encoder and foot switch
A
inputs
X,Y and Z axis CNC control outputs
B
IK 5000 card connection to Flyout
C
connectors H and J
IK 5000 card connection to Flyout
D
connector K
IK 5000 card power connector
E
IK 5000 card connection to flyout
F
connector N
Minimum system requirements
Component w/o 3D profiling
PC 2.66 GHz dual-core Pentium
Operating System Windows Vista 32-bit
(OS)
Windows 7 32-bit, 64-bit
Windows 8 32-bit, 64-bit
Windows 10 32-bit, 64-bit
1GB
RAM
Available Hard Disk 500MB
PCI 1 PCI slot and 1 to 3 additional empty slots (depending on the
version)
Video Display Unit 1024 x 768 resolution
Windows users rights Administrator
18
Interface connections
IK 5000 card PCI connector to PC
G
motherboard
Q axis encoder input
H
DIP switches for interpolation
I
settings
Q axis CNC control output
J
Video light outputs
K
M Touch probe input
w/ 3D profiling
2.8 GHz quad-core Pentium
2GB
1GB
Interface connections
Camera zoom control output
N
Comparator light source input for
P
optical edge detection
Comparator screen sensor input for
R
optical edge detection
Optical daughter board optical cables
T
through connectors P and R to
the comparator light source and
screen sensor
TP200 daughter board connection to
V
flyout connector M
W RS-232 PC motherboard connector