Mercedes-Benz C-Class Coupe 2019 Operator's Manual page 409

Press the wheel firmly against the
#
wheel hub when screwing on the first
wheel bolt.
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated until they are
finger-tight.
Unscrew the alignment bolt.
#
Tighten the last wheel bolt until it is finger-
#
tight.
Lower the vehicle ( page 407).
/
#
Lowering the vehicle after a wheel change
Requirements:
The new wheel has been installed
R
( page 406).
/
To lower the vehicle: turn the crank of the
#
jack counter-clockwise until the vehicle is
once again standing firmly on the ground.
Tighten the wheel bolts evenly in a diagonal
#
pattern in the order indicated
Specified tightening torque: 96 lb-ft
(130 Nm).
& WARNING Risk of injury through incor‐
rect tightening torque
The wheels could come loose if the wheel
bolts or wheel nuts are not tightened to the
prescribed tightening torque.
Make sure the wheel bolts or wheel
#
nuts are tightened to the prescribed
tightening torque.
If you are not sure, do not move the
#
vehicle. Consult a qualified specialist
workshop and have the tightening tor‐
que checked immediately.
Check the tire pressure of the newly moun‐
#
ted wheel and adjust accordingly.
Vehicles with tire pressure loss warning
#
system: Restart the tire pressure loss warn‐
ing system (
Vehicles with a tire pressure monitoring
#
(1 to 5).
system: Restart the tire pressure monitoring
system (
Make sure to observe the following further rela‐
ted subject:
Notes on tire pressure (
R
Wheels and tires 407
page 385).
/
page 384).
/
page 379)
/