Belkin OmniView F1DW116C User Manual page 20

Belkin user manual omniviewtm kvm switch with cat5 extension f1dw116c, f1dw216c enterprise quad-bus series

Hide thumbs Also See for OmniView F1DW116C:

Table of Contents

Daisy-Chain Configuration

• The 7-segment display of a secondary Switch will always display its BANK

address. All other buttons and LEDs on secondary BANKs will be disabled.

Static Mode (Idle)

• The 7-segment LEDs will display the current BANK ID.

• The Port Selection and Shift LEDs will be off.

• The Console LED will be lit, indicating that this Switch is a console.

The Switch will go into Select Mode when you press and release any button on the

front panel of the console. The Port Selection LEDs will toggle from off to on, and

the 7-segment LEDs will toggle from indicating the BANK ID to indicating the BANK

in focus.

Select Mode

• Select Mode reverts to Static Mode after 5 seconds of inactivity.

• The 7-segment LEDs will display the address of the BANK in focus.

• One Port Selection LED will be lit, corresponding with the port in focus on the

BANK in focus.

• The Shift LED will light whenever ports 9–16 are selected. To use the 1x8 or 2x8

KVM Switch to select ports 9–16 on a 1x16 or 2x16 KVM Switch, hold down the

corresponding button for one second (the Shift LED will light) then release it.

For example, to select the computer attached to port 9, from Select Mode, press

the button for port 1, and hold it for one second before releasing it; the Switch

will beep and both the Port 1 LED and Shift LED will light.

• The Primary Console LED will be lit, indicating that this Switch is a console.

1. Press the BANK selection buttons to cycle through the BANKs available; each

press increases or decreases the BANK in focus by one, and is immediately

indicated by the 7-segment LEDs.

2. Press the button corresponding to the port that you would like to select. When

you release the button, the Switch will beep, and change the focus to the

selected port. If the user has been restricted from accessing the selected port, a

banner message will display "Access Denied".

3. If you press the AutoScan button, when you release the button, the Switch will

beep, and change into AutoScan Mode.

USING YOUR SWITCH

Table of Contents

Omniview f1dw216c