Description Of Hardware; Smc7724M/Vsw Ee Switch - SMC Networks SMC7724M/VSW Installation Manual

Description of Hardware

SMC7724M/VSW EE Switch

SMC's SMC7724M/VSW EE Switch together with the SMC7024/VSP or
SMC7048/VSP EE Splitter, combines data and voice signals for delivery
over standard telephone cable to multiple users in residential or
commercial buildings. Ethernet data signals are received on the switch
uplink port and passed to 24 VDSL lines via 24 internal Ethernet ports.
These 24 VDSL lines are then passed to the splitter via the RJ-21
connector on the rear panel.
The switch supports optional single-port modules for 1000BASE-T,
1000BASE-X GBIC, 100BASE-FX multimode and single-mode, and
10/100BASE-TX. It also has an SFP slot for Gigabit transceivers. The
fiber module and transceiver ports can provide direct connection to your
ISP with fiber optic cable. In a switch stack, any of the module ports can
also function as uplinks to the backbone, or as regular switch ports for
networking.
Stacking is not supported in the current firmware version.
Note:
The speed, duplex mode, and flow control for the optional module, GBIC
transceiver, and SFP transceiver ports are shown below.
Port Type
1000BASE-T
1000BASE-X
100BASE-FX
10/100BASE-TX
If the attached device does not support auto-negotiation, you will
Note:
have to manually configure the other device to match the duplex
mode and speed, otherwise it may default to half duplex.
Speed
auto
1000 Mbps
100 Mbps
10/100 Mbps
D
ESCRIPTION OF
Duplex Mode
full duplex
full duplex
full duplex
auto
H
ARDWARE
Flow Control
auto
auto
auto
auto
1-7