Attach To Your Network Using Ethernet Cabling; Connect The Power Adapter - SMC Networks Barricade SMC7908VoWBRA User Manual

I
NSTALLATION

Attach to Your Network Using Ethernet Cabling

The four LAN ports on the Barricade auto-negotiate the connection speed
to 10 Mbps Ethernet or 100 Mbps Fast Ethernet, as well as the
transmission mode to half duplex or full duplex.
Use RJ-45 cables to connect any of the four LAN ports on the Barricade
to an Ethernet adapter on your PC. Otherwise, cascade any of the LAN
ports on the Barricade to an Ethernet hub or switch, and then connect
your PC or other network equipment to the hub or switch. When inserting
an RJ-45 connector, be sure the tab on the connector clicks into position
to ensure that it is properly seated.
Warning: Do not plug a phone jack connector into an RJ-45 port. This
Notes: 1. Use 100-ohm shielded or unshielded twisted-pair cable with
2. Make sure each twisted-pair cable length does not exceed

Connect the Power Adapter

Plug the power adapter into the power socket on the rear of the Barricade,
and the other end into a power outlet.
Check the power indicator on the front panel is lit. If the power indicator is
not lit, refer to "Troubleshooting" on page A-1.
In case of a power input failure, the Barricade will automatically restart and
begin to operate once the input power is restored.
2-8
may damage the Barricade.
RJ-45 connectors for all Ethernet ports. Use Category 3, 4, or 5
for connections that operate at 10 Mbps, and Category 5 for
connections that operate at 100 Mbps.
100 meters (328 feet).