Advertisement
5. Make a loop in the cable assy. as shown figure below. Fix the cable to the mounting
base with two cable ties (CV-150B).
6. For FI-501/FI-502: Pass the cable assy. through the mast and connect it to the port at
the rear of the instrument. If the connector of the cable can not be passed through the
mast (because inside diameter of mast is too small), use the terminal box (supplied)
to make the connection. For wiring with the terminal box, see the FI-501/FI-502 oper-
ator's manual.
For FI-70: To use the FI-5001/L sensor data for the FI-70, it is required to convert the
analog data to the CAN bus (NMEA2000) format data with the IF-NMEAFI. For details
of wiring, see the FI-70 operator's manual.
Cable assy.
FI-50-SENSOR-30/50
(30 m or 50 m)
Cable tie
(CV-150B)
Terminal box
3
Advertisement
