System Defaults - SMC Networks TIGERSWITCH 10/100 Management Manual

S M
WITCH ANAGEMENT
also provides a facility to upload firmware files to the system
directly through the console port. See "Upgrading Firmware via
the Serial Port" on page B-1.
Due to the size limit of the flash memory, the switch supports only
one operation code file, and two diagnostic code files. However,
you can have as many configuration files as available flash
memory space allows.
In the system flash memory, one file of each type must be set as
the start-up file. During a system boot, the diagnostic and
operation code files set as the start-up file are run, and then the
start-up configuration file is loaded. Configuration files can also be
loaded while the system is running; however, this will
automatically reboot the switch.

System Defaults

The switch's system defaults are provided in the configuration file
"Factory_Default_Config.cfg." To reset the switch defaults, this file
should be set as the startup configuration file (page 2-22).
The following table lists some of the basic system defaults.
Function
IP Settings
Web
Management
1-14
Parameter
Management VLAN
IP Address
Subnet Mask
Default Gateway
DHCP
BOOTP
HTTP Server
HTTP Port Number
Default
1
0.0.0.0
255.0.0.0
0.0.0.0
Disabled
Disabled
Enabled
80