Rowenta PRO COMPACT User Manual page 6

Place the base of your garment steamer on
the floor. Ensure the floor is a flat, stable,
heat-resistant surface. Never carry or lift this
product over floor height while in use.
• During operation, the steamer hose may
make a gurgling noise. This is a normal result
of condensation. If it begins to gurgle, extend
hose up and out to allow any excess
moisture back into the base.
Do not allow steamer to run dry.
Accessories
(depending on model)
Reminder: When using accessories steam
only in an up and down vertical motion.
Never use the steam head in a horizontal
position and never steam with the
steamhead upside down.
Before using any of the accessories on
upholstery or garments, be sure to consult the
manufacturer regarding their recommendations.
We also recommend
inconspicuous area.
Upholstery brush*
The upholstery brush is used to aid steam
penetration into difficult, heavy fabrics, for faster
results.
Be sure unit is unplugged and completely
cool before attaching accessories.
• Attach the upholstery brush to the steam head
by lining up the bottom of the brush with the
bottom of the steam head. Gently push the top
of the brush into place on the steam head until
it clicks into place -
• Gently brush the area to be steamed with the
grain or nap of the fabric.
• Remove the upholstery brush once the unit is
unplugged and completely cool. Remove it by
pressing on the tab on top of brush while
pulling it forward.
Fabric brush*
The fabric brush opens the weave of the fabrics
for better steam penetration.
Be sure unit is unplugged and completely
cool before attaching accessories.
*depending on model: these accessories are either equipment specific to certain models or available as an
6
optional accessory.
testing on
fig.7.
• Attach the fabric brush to the steam head by
lining up the bottom of the brush with the
bottom of the steam head. Gently push the top
of the brush into place on the steam head until
it clicks into place.
• Gently brush the area to be steamed with the
grain or nap of the fabric.
• Remove the fabric brush once unit is
unplugged and completely cool. Remove it by
pressing on the release tab on top of brush
while pulling it forward.
Crease attachment*
The crease attachment allows you to make
trouser creases easily and remove stubborn
creases.
Be sure the unit is unplugged and completely
cool before attaching accessories.
• Fasten the crease attachment to the steam
head by inserting it into the slide under the
steam brush - fig.8.
an
• Gently push into place.
• Push on the handle to open out the crease
attachment - fig.9.
• Put your fabric in the space between the
crease attachment and the steam brush
fig.10.
• Release the handle.
• Move the crease attachment in a downwards
motion starting from the top
• Once unit is unplugged and completely cool,
remove the crease attachment by sliding it out
of the steam brush.
Lint pad*
The lint pad removes hair, lint and animal fur
for a professional finish.
The lint pad is a separate accessory and
cannot be attached to the steam head. You can
use the lint pad independently from the
steamer.
• To use the lint pad, slowly brush the clothing
with the grain or nap of the fabric.
•The pad can be cleaned by brushing it in the
opposite direction. We recommend cleaning
the pad onto an old cloth that can be
discarded.
-
- fig.11.