Avaya ERS 4500 Technical Configuration Manual page 14

2.5.2 Restart the UTPS service
After you have enabled Avaya Automatic QoS, you need to restart the utps service. Start by clicking on
the Administration icon via the Task Navigation Panel and click on Service Manager. Scroll down to utps
and click the Restart icon and select Yes to restart the service.

Warning – use caution when restarting the UTPS as all IP Sets registered with the BCM
server are temporarily reset.
Note: These Business Element Manager screen shots are from an Avaya BCM 50

system. The process on an Avaya BCM 450 is the same, although the setting is
referred to as "Avaya on Avaya".
Note: the Avaya BCM200/400 does not support NT_on_NT settings or the ability to

remark DSCP values at source, although it is possible to re-mark DSCP values for
traffic egressing any BCM interface using the built-in BCM Firewall configuration and
manually configuring new rules.
Ethernet Routing Switch 4500, 5000, Avaya BCM 50, 450, Avaya CS 1000, Avaya CS 2100, Avaya SRG 50
avaya.com
13