Table of Contents
Advertisement
COPIER (Service mode for printer) > OPTION (Specification setting mode) > CUSTOM
PDLEVCT1
2
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
ABK-TOOL
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Supplement/Memo
DFEJCLED
1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
RDEV-SP1
2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
RDEV-SP2
2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Set event skipping at continuous PDL job
To set event skipping at continuous PDL job.
During continuous operation, processing performance may be decreased due to other events
generated by the event in operation. In this case, decrease of processing performance can be
prevented by skipping the amount of event.
Processing performance: No event skipping < Subject of skipping 1
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: No event skipping, 1: Subject of skipping 1
1
Allow access from address book mntc tool
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to accept import from the address book maintenance tool.
When executing import from the address book maintenance tool
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Disabled, 1: Enabled
0
Address book maintenance tool: Tool provided from CMJ.
ON/OFF of DADF Delivery Display LED
To set whether to light up the Delivery Display LED of DADF.
Upon user's request (The Delivery Display LED is too bright)
Enter the setting value, and then press OK key.
0 to 1
0: ON, 1: OFF
0
RCON device special settings 1
To execute the device special setting.
For customization
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Use this mode only when specific instructions are given.
00000000 to 11111111
0
RCON device special settings 2
To execute the device special setting.
For customization
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Use this mode only when specific instructions are given.
00000000 to 11111111
0
483
8. Service Mode
Advertisement
Table of Contents
