:
Transfer from 'on bypass' to 'on inverter' mode:
Using the system control panel
1.
Press the Home button on the display header bar.
a) The HOME screen should open.
2.
Press the Command button of the HOME screen.
a) The COMMAND screen should open.
3.
Press the Load to Inverter button on the COMMANDS screen
a) All UPS modules will transfer the load to the inverter
4.
On the system control panel check that the UPS
mimic indicates the load on inverter.
5.
Check that the display header Load Status
indicates that the load is protected.
58
L.2
L.1
rectifier
TS_622_02 PowerWAVE 9500DPA User Manual 26/2/19
load
inverter