Optional On Demand Control Center - Suburban NAUTILUS IW60 Installation And Operation Manual

OPTIONAL ON DEMAND CONTROL CENTER

6
5
3 4
1
7 8 9
°C/°F
1
2
3
4
5
2
6
7
10
8
9
10
Figure 13
MOUNTING HOLES
Figure 14
11
DISPLAY DESCRIPTION
BURNERS
FLAME
BLOWER
STATUS
INDICATOR
SETTING TEMP
INDICATOR;
OUTLET WATER
TEMP INDICATOR
FREEZE
PROTECTION
BUTTON DESCRIPTION
ON/OFF
SWITCH
°C/°F
UP
DOWN
KNOCK OUT
2 BURNERS
5 BURNERS
This icon is displayed when
FLAME is established.
This icon is displayed when the
BLOWER is running
This icon is displayed when the
Water Heater is in standby mode,
ready to be used.
A.
When setting the water temperature,
the temperature display will flash.
After SET Temperature is reached,
the display stops flashing after a few
seconds.
B.
When the demand for hot water has
been terminated, the display will return
to the SET Temperature.
C.
When the water heater is turned off,
the letters "OF" will be display.
This icon is displayed when
the FREEZE PROTECTION
MECHANISIM is engaged.
Power Button. Switch from turning
unit ON or turning unit OFF.
Hold for 5 seconds to switch
between degrees (°) Celcius or
degrees (°) Fahrenheit
INCREASE SET Temperature
by 1 degree increments. Setting
range is 35°C/95°F to 55°C/130°F
DECREASE SET Temperature
by 1 degree increments. Setting
range is 35°C/95°F to 55°C/130°F