Water Separator-Alert Indicator Blinks While Cruising - Yamaha F225 Owner's Manual

1. Manual valve screw
3. Tilt the outboard motor up manually to
the desired position, and then tighten the
manual valve screw by turning it clock-
wise.
EMU41891
Water separator-alert indicator blinks
while cruising
EWM02543
WARNING
Gasoline is highly flammable, and its va-
pors are flammable and explosive.
Do not perform this procedure on a hot

or running engine. Allow the engine to
cool.
There will be fuel in the fuel filter. Keep

away from sparks, cigarettes, flames or
other sources of ignition.
Some fuel will spill during this proce-

dure. Catch the fuel in a rag. Wipe up
any spilled fuel immediately.
The fuel filter must be reassembled

carefully with the O-ring and filter cup
in place. Improper assembly or replace-
ment could result in a fuel leak, which
could result in a fire or explosion haz-
ard.
If the water separator-alert indicator blinks,
perform the following procedure.
1. Stop the engine.
2. Remove the top cowling.
3. Remove the bolts, and then remove the
1
fuel filter cover.
ZMU07196
1. Bolt
2. Fuel filter cover
4. Disconnect the water detection switch
coupler. NOTICE: Be careful not to get
any water on the water detection
switch coupler, otherwise a malfunc-
tion could occur.
1. Water detection switch coupler
5. Remove the filter cup from the filter
housing, and then remove the O-ring
from the filter cup. NOTICE: Be careful
not to twist the water detection
switch lead when unscrewing the fil-
ter cup.
Trouble Recovery
[ECM01951]
[ECM01961]
1
2
1
ZMU07519
1
ZMU07520
101