Safety Instructions For Maintenance; Assembly; Operation - McCulloch M46-120M CLASSIC Operator's Manual

• Do not get fuel on your body, it can cause injury. If
you get fuel on your body, use soap and water to
remove the fuel.
• Do not start the product if the engine has a leak.
Examine the engine for leaks regularly.
• Be careful with fuel. Fuel is flammable and the fumes
are explosive and can cause injuries or death.
• Do not breathe in the fuel fumes, it can cause injury.
Make sure that there is a sufficient airflow.
• Do not smoke near the fuel or the engine.
• Do not put warm objects near the fuel or the engine.
• Do not add the fuel when the engine is on.
WARNING: Read the warning instructions
that follow before you use the product.
• The exhaust fumes from the engine contain carbon
monoxide, an odourless, poisonous and very
dangerous gas. Do not start the engine indoors or in
closed spaces.
• Before you do the maintenance on the product, stop
the engine and remove the ignition cable from the
spark plug.
• Use protective gloves when you do maintenance on
the cutting equipment. The blade is very sharp and
cuts can easily occur.
To assemble the handle
1. Put the stay into the lower handle.(Fig. 18 )
2. Put the lower handle in the recesses on the cutting
cover.(Fig. 19 )
3. Press the plastic plugs through the holes to attach
the handle.(Fig. 20 )
4. Put the stay in the groove on the cutting cover.(Fig.
21 )
5. Attach the 2 stops that lock the stay and the handle.
Press them fully in position.(Fig. 22 )
Note: There are two stops, one identified with an H
and one with a V. Put the stop with an H on the right
side and the stop with a V on the left side.
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
8

Safety instructions for maintenance

Assembly

Operation

• Make sure that the engine is cool before you refuel.
• Before you refuel, open the fuel tank cap slowly and
release the pressure carefully.
• Do not add fuel to the engine in an indoor area. Not
sufficient airflow can cause injury or death because
of asphyxiation or carbon monoxide.
• Tighten the fuel tank cap fully. If the fuel tank cap is
not tightened, there is a risk of fire.
• Move the product a minimum of 3 m (10 ft) from the
position where you filled the tank before a start.
• Do not put too much fuel in the fuel tank.
• Accessories and changes to the product that are not
approved by the manufacturer, can cause serious
injury or death. Do not change the product. Always
use accessories that are approved by the
manufacturer.
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Only do the maintenance as given in this owner's
manual. All other servicing must be done by an
approved McCulloch service agent.
• Let an approved McCulloch service agent do
servicing on the product regularly.
• Replace damaged, worn or broken parts.
CAUTION: Do not operate the product if
the 2 stops are not attached.
6. Align the holes in the handlebar with the holes in the
lower handle and attach the screws, washers and
knobs.(Fig. 23 )
7. Tighten the knobs fully.
Before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
229 - 004 - 21.11.2017