Vx-350 Series Vhf Band Service Manual - Vertex Standard VX-350 Series Service Manual

Alignment
7. S A D
UB UDIO EVIATION
This parameter is to align the Deviation of Sub-Audio (CTCSS/DCS). The "Max Deviation" must be done before this alignment is
started.
There are several alignments as follows in the Sub Audio Deviation.
CTCSS Daviation <Wide> "CTCSS ( W ) ":
CTCSS Daviation <Narrow> "CTCSS ( N ) ": The Alignment for the CTCSS Daviation level at Narrow.
DCS Daviation <Wide> "DCS ( W ) ":
DCS Daviation <Narrow> "DCS ( N ) ":
The procedure for all the alignment is as follows.
1. Set the transceiver to Band Center frequency.
2. Press the "START" button to start the alignment.
3. Set the value to get desired deviation (referring to the table
below) by left/right arrow key, drag the slide bar by mouse,
or direct number input.
4. Press the "OK" button after getting the desired value to save
the re-aligned value, the alignment of the SUB AUDIO DE-
VIATION is accomplished.
0.7 kHz ± 0.05 kHz
CTCSS ( W )
0.4 kHz ± 0.05 kHz
CTCSS ( N )
0.7 kHz ± 0.05 kHz
DCS ( W )
0.4 kHz ± 0.05 kHz
DCS ( N )
8. B
ATTERY
This parameter is to align the "Low Battery Level" voltage and "EEPROM Protect Level" voltage.
1. Press the "START" button of "Low Batt Level" to start the
alignment.
2. Set the DC Power voltage to 6.5V (according to the indica-
tion) and press the "OK" button.
3. Press the "START" button of "EEPROM Protect" to start
the alignment.
4. Reduce the DC Power voltage to 5.5V (according to the
indication) and press the "OK" button.
5. Press the "OK" button on the confirmation window, then
increase the DC Power voltage to 7.5V (according to the
indication) and press the "OK" button.
6. Press the "OK" button, then the data will be saved and the
alignment is accomplished.
CH ( C
- -C
HANNEL BY HANNEL
The CH Fine Alignment Mode allows you to align the radio separately for every operating channel. The value of each parameter can
be changed to the desired position using the "" / "" / "" / "" arrow keys, direct number input, and by dragging the PC mouse.
To enter the CH Fine Alignment Mode, select "CH Fine Align-
ment" in the main "Radio" menu. It will start to "Upload" the
written personalized data from the radio. Pressing the "OK"
button will then start the CH Fine Alignment Mode.
Note: Detailed information for each step may be found in the
"Help" file within CE86 (Clone Editor).

VX-350 Series VHF Band Service Manual

<CTCSS> / <DCS>
The Alignment for the CTCSS Daviation level at Wide.
The Alignment for the DCS Daviation level at Wide.
The Alignment for the DCS Daviation level at Narrow.
) F
A M
INE LIGNMENT ODE
13