Fisher & Paykel DE7060M Installation Manual page 34

PROBLEM
Dryer is taking
too long
/results were
not satisfactory
Noises
Vibration
Creasing
Dye transfer
32
TROUBLESHOOTING
POSSIBLE CAUSES
Drying cycle selected not
appropriate for the load.
Dryness level selected not
appropriate for the load.
Dryer overloaded for
the cycle.
Lint filter is blocked.
Load overly wet at the start
of cycle.
Load was damp dry at the
start of cycle.
Items got tangled.
Dryer is overloaded.
Dryer has a fault.
Dryer is not installed on
a stable surface.
Dryer is overloaded.
'Dry Temp' and/or
'Dryness Level' selected
too hot/too long for
load type (DE7060M,
DE6060M, DE5060M and
DE5060MU only).
White/light and coloured
items not separated
before drying.
Wet items left sitting in
the dryer for long periods
of time before drying.
WHAT TO DO
Select an appropriate cycle for the
load. Refer to 'Drying cycles'.
Select a higher dryness level. Refer to
'Dryness Level'.
Some cycles have a lower max load
size. Refer to 'Drying cycles'.
Try dividing the load in half and
dry half at a time.
Clean the lint.
Remove more water from the
load before placing it in the dryer,
eg select a faster spin speed on your
washer, if appropriate for your load.
If the load had been partially air dried,
eg has been washed and placed on
the line, use a 'Time Dry' cycle and
monitor the dryness of your clothes.
Try separating items and drying similar
items together. Refer to 'Loading'
for further tips.
Remove some items from the dryer.
Dryer is beeping and displaying
unfamiliar light patterns and/
or message on the digital display.
Refer to 'Before you call for service'.
Ensure the dryer is installed on a flat,
stable surface.
Remove some items from the dryer.
Try selecting a lower 'Dry Temp' and
'Dryness Level'
Remember to separate white/light and
coloured items before placing them in
the dryer.
Refer to 'Sorting' for tips to prevent
dye transfer.