Fisher & Paykel DE7060M Installation Manual page 14

Wall mounting
Determine the position of the dryer on the wall and mark the bracket
1
position. A minimum of 50mm is needed between the top of the dryer
and the ceiling for ease of installation. If mounting above a washing machine,
allow sufficient room to open the lid of the washer.
Refer to page 11 for lid clearances.
Fix the wall hanging brackets to
2
the wall securely, ie into the stud.
If the studs are too far apart, fit
a timber slat to the studs and
then mount the brackets to the
slat. If a slat is used, install a
second slat behind the spacers
to ensure the dryer is horizontal.
The distance between the centre
of each bracket is 555mm (A).
To install the hooks onto the
3
dryer, remove one screw from
each side (B), reuse these
screws with two more (each side)
from the kit to fasten the hooks
in place.
Remove plastic plugs from the
4
back of the dryer and screw the
spacers provided in place (C).
With assistance, mount the dryer
5
on the wall brackets.
Fit inverted control panel over
6
the existing panel.
Adjust the display to read
7
correctly on an inverted panel:
For DE7060M, DE6060M
● ●
and DE5060M press
for three seconds.
For DE4560M press
● ●
for three seconds.
The dryer will beep to indicate
● ●
you have made a correct
selection, and the display will
change after three seconds.
Repeat the same steps
● ●
to return the panel to the
factory setting.
12
INSTALLATION INSTRUCTIONS
and
and
A
835mm
B
C