To Replace The Chain Catcher; To Replace The Spiked Bumper; Drive Wheel Cover And Guide Bar; Crankcase - Husqvarna T536LiXP Workshop Manual

5.6 To replace the chain catcher

Always replace a worn chain catcher with a new one.
1. Disassemble the drive wheel cover, the saw chain
To remove the drive wheel cover
and the guide bar.
and guide bar on page 9 .
2. Remove the screw and replace the chain catcher.

5.7 To replace the spiked bumper

Always replace a worn spiked bumper with a new one.
1. Disassemble the drive wheel cover, the saw chain
and the guide bar. See
cover and guide bar on page 9
2. Remove the screws and replace the spiked bumper.
539 - 003 - 05.12.2018
To remove the drive wheel

5.8 Drive wheel cover and guide bar

5.8.1 To remove the drive wheel cover and
guide bar
1. Release the chain brake, move the hand guard
rearward.
2. Remove the drive wheel cover and guide bar nut.
3. Remove the cover, saw chain and guide bar.
5.8.2 To assemble the drive wheel cover and
guide bar
• Assemble the drive wheel cover and guide bar in the
opposite sequence of
cover and guide bar on page 9 .

5.9 Crankcase

5.9.1 To disassemble the crankcase
CAUTION: Make sure that all parts are put
correctly in the crankcase to prevent damage to
the cables.
1. Remove the 8 screws.
2. Remove the crankcase half.
5.9.2 To assemble the crankcase
• Assemble the crankcase in the opposite sequence
To disassemble the crankcase on page 9 .
of
To remove the drive wheel
Repair instructions - 9