Optional Smartrunk Ii™ Operation - Icom IC-F1020 Instruction Manual

o
Terminating a call
After completing a call, push [#] to disconnect (hang up).
~
IMPORTANT: If one person in the conversation terminates
~
a call, all participants will be cut off.
o
Last number redial
Push [*], [*] to automatically redial the last number called.
• A high-pitched beep indicates that the number is accepted.
~
Memory speed-dialing
To automatically dial a commonly used number from memory:
• Push
[*]
followed by the memory location (0-9).
o
Turbo SpeeDial
To automatically dial a commonly used number with one
push:
• Push one of the turbo SpeeOials ([A], [B], [C] or [OJ).
OPTIONAL SmarTrunk II™ OPERATION
4
~
Programming memory speed dial
CD
Push and hold [*] until you hear a high-pitched beep.
@
Enter the memory location (0-9, A, B, C, 0), the telephone
or subscriber number, then [1],
[*]
(or [3],
[*]
iffor another
system subscriber).
• A high-pitched beep indicates successful programming.
• Memories [A]-[D] are used for the Turbo SpeeDial.
<>
System busy indication
If all channels are busy, three low beeps sound after you initi-
ate a call. Try the call again later.
~
PTT dispatch operation
CD
Push [PTT] once (without dialing) to initiate a dispatch call.
@ Begin talking after you hear three beeps (one short, high-
pitched, two very-short, low-pitched).
ell
Receiving a dispatch call is indicated by the same three-
beep sequence.
• It is not necessary to push
[*]
to answer a dispatch call.
o
Emergency call
Push
[0], [*]
to initiate an emergency call .
• Contact your dealer for details.
14