Optional Unit Installation; I Ut-113 Installation; I Ut-108 Installation - Icom IC-F43TR Instruction Manual

Uhf trunked radio

Hide thumbs Also See for IC-F43TR:

Table of Contents

OPTIONAL UNIT INSTALLATION

Install the optional UT-113

q Rotate [VOL] to turn the power OFF, and remove the bat-

tery pack. (p. 2)

w Remove the unit cover.

NOTE: Use a ﬂat head screw driver or a similar ﬂat instrument,

and insert into the hollow of the chassis, then lift and take away

the unit cover. (The removed cover cannot be used again.)

e Install the unit as shown below.

r Replace the unit cover and the battery pack, then rotate

[VOL] to turn the power ON.

as follows:

MAN DOWN UNIT

Install the optional UT-108

DTMF DECODER UNIT

q Rotate [VOL] to turn the power OFF, and remove the bat-

tery pack. (p. 2)

w Remove the unit cover as shown at left.

e Cut and solder the pattern on the PCB at the RX AF cir-

cuit as shown below.

r Install the UT-108

DTMF DECODER UNIT

described in the optional UT-113 installation as shown at left.

t Replace the unit cover and the battery pack, then rotate

[VOL] to turn the power ON.

NOTE: Be sure to un-solder A and B, and re-solder B and

C, otherwise no AF output is available when you remove

the DTMF decoder unit.

as follows:

the same way as

Table of Contents