Perform A Speed Test - NETGEAR CM1150V User Manual

Note To install your cable modem, use Ethernet port 1. Your cable modem comes with
plugs that cover Ethernet ports 2, 3 and 4. These ports can be used to connect a
router that supports Ethernet port aggregation. Your cable modem might not support
Ethernet port aggregation the first time that you set it up. Check
to find out if your cable modem supports Ethernet port aggregation yet.
Figure 6. Connect your cable modem to a router
To connect your cable modem to a router after installation and activation:
1. Reboot your cable modem by unplugging the power cable from the cable modem and plugging it back
in.
Wait for the Online LED to stop blinking and light solid green.
2. Use an Ethernet cable to connect the Ethernet port on your cable modem to the WAN or Internet port
on the router.
3. Power on your router.
4. Wait until your router is ready.
5. Connect a computer to your router.
For more information about how to set up your router, see the documentation that came with your router.

Perform a Speed Test

To determine the accurate Internet speed, visit
If your actual speed is lower than your subscribed speed, contact XFINITY.
Voice Cable Modem
speedtest.xfinity.com/
Hardware Setup
13
netgear.com/support
and perform a speed test.