Stihl FS-KM Instruction Manual page 7

THE POWER TOOL (KOMBIENGINE
EQUIPPED WITH TRIMMER /
BRUSHCUTTER / CLEARING SAW
KOMBITOOL)
For illustrations and definitions of the
power tool parts see the chapter on
"Main Parts."
WARNING
Never modify this power tool in any way.
Only attachments supplied by STIHL
and expressly approved by STIHL for
use with the specific STIHL
KombiEngine are authorized. Although
certain unauthorized attachments are
useable with STIHL power tools, their
use may, in fact, be extremely
dangerous.
For the cutting attachments authorized
by STIHL for your unit, see the chapter
"Approved Combinations of Cutting
Attachment, Deflector, Handle and
Harness" in the instruction manual or the
STIHL "Cutting Attachments, Parts &
Accessories" catalog.
If this tool is subjected to unusually high
loads for which it was not designed (e.g.
heavy impact or a fall), always check
that it is in good condition before
continuing work. Check in particular that
the fuel system is tight (no leaks) and
that the controls and safety devices are
working properly. Do not continue
operating this machine if it is damaged.
In case of doubt, have it checked by your
STIHL servicing dealer.
FS-KM
THE USE OF THE POWER TOOL
(KOMBIENGINE EQUIPPED WITH
TRIMMER / BRUSHCUTTER /
CLEARING SAW KOMBITOOL)
Transporting the Power Tool
WARNING
To reduce the risk of injury from loss of
control and blade or line contact, never
carry or transport your power tool with
the cutting attachment moving.
WARNING
Always switch off the engine and make
sure the working tool has stopped before
putting a power tool down.
It may be carried only in a horizontal
position. Grip the shaft in a manner that
the machine is balanced horizontally.
Keep the hot muffler away from your
body and the cutting attachment behind
you.
WARNING
To reduce the risk of burn injury, do not
touch hot parts of the machine and the
gear housing when they are hot.
WARNING
When transporting it in a vehicle,
properly secure it to prevent turnover,
fuel spillage and damage to the unit.
STIHL recommends that you keep metal
blades covered with the transport guard
(optional accessory).
Before Starting
WARNING
Always check your power tool for proper
condition and operation before starting.
Never attempt to modify the controls or
safety devices.
WARNING
Never use a power tool that is damaged
or not properly maintained.
WARNING
Do not attach any cutting attachment to
a unit without proper installation of all
required parts. Failure to use the proper
parts may cause the blade or head to fly
off and seriously injure the operator or
bystanders.
English
5