Stopping; Checking Chain Tension; Chain Lubrication Test - Echo CS-310 Operator's Manual

OPERATION

Stopping

1. Release throttle trigger and allow
engine to idle.
2. Move ignition switch (A) DOWN
to "STOP" position.
Note: If engine does not stop,
pull choke control knob out
fully to stop engine.
Note: Return the unit to your
authorized dealer to check
and repair stop switch before starting the engine again.

Checking Chain Tension

Chain tension should be checked
frequently during work and corrected
as necessary.
Do not operate with a loose chain.

Chain Lubrication Test

Hold the chain just above a dry
surface and open the throttle to half
speed for 30 seconds.
A thin line of "thrown" oil should be
seen on the dry surface.
34
CS-310
A
X7503275401
© 02/2019 ECHO Inc.