Outer Case Removal; Terminal Insulator Removal; Power Supply Cord Removal - Electrolux ICON E30SO75ESS Technical & Service Manual

Component Teardown

Outer Case Removal

1. Disconnect oven from power supply before
removing outer case.
2. Discharge the high voltage capacitor before
touching any oven components or wiring.
1. Disconnect the power supply cord.
2. Open the oven door and block it open.
3. Remove the two (2) special screws from the lower
portion of the back plate using a T20H Torx type or
GTXH20-100 screw driver.
4. Remove the four (4) screws holding the upper side of
the outer case cabinet to the back plate.
5. Remove the four (4) screws holding the right and left
sides of the outer case cabinet to the bottom plate.
6. Slide the entire outer case cabinet back out about 1
inch (3cm) to free it from retaining clips on the oven
cavity front plate.
7. Lift entire outer case cabinet from the unit.
Special Screw
Screwdriver
(Type: TORX T20 H or
GTXH20-100)
Figure 4-1. Case Removal
When replacing the outer case cabinet, the two (2)
special Torx screws must be reinstalled in the same
locations.

Terminal Insulator Removal

1. Open covers of the terminal insulator by using a
small flat type screw driver.
2. Remove the receptacle from the terminal insulator.
3. Now, the terminal insulator is free.
Installation
1. Insert the receptacle into terminal insulator.
2. Close covers of the terminal insulator.
(See Figure 4-2)
Flat type
Screwdriver
Terminal
Insulator
Figure 4-2. Terminal Insulator Removal

Power Supply Cord Removal

Removal
1. Disconnect power supply cord and remove outer
case.
2. Open the oven door and block it open.
3. Discharge the high voltage capacitor.
To discharge the high voltage capacitor, wait for 60
seconds and then short-circuit the connection of
the high-voltage capacitor (that is the connecting
lead of the high-voltage rectifier) against the
chassis with the use of an insulated screwdriver.
4. Remove the one (1) screw securing the green wire of
the power supply cord to the bottom plate.
5. Disconnect the black wire of the power supply cord
from the fuse holder, and the white wire from the
main wire harness.
6. Nip the cord bushing with bushing pliers and release
it from the hole of the back plate.
7. Remove the cord bushing from the power supply
cord, then remove power supply cord from the back
plate.
4-2
Covers
Receptacle