Removal Of Oven From Wall; Hood Louver Removal; Outer Case Removal - Electrolux EI30BM55HB Technical & Service Manual

Component Teardown

Removal of Oven From Wall

(Two persons recommended to remove the oven)
1. Disconnect the power supply cord, and uncoil the
power supply cord.
2. Remove the turntable tray and support from the
oven cavity.
3. While supporting the front of the oven, unfasten
the two (2) screws holding oven to the unit
mounting plate.
4. While supporting the oven, remove the two (2)
screws holding oven (outer case cabinet) to the
top cabinet.
5. Remove the oven from the unit mounting plate
and pull the power cord out of the wall cabinet.
6. The oven is now free and can be placed on the
work surface selected for servicing the oven.
7. Installation is the reverse of this procedure.

Hood Louver Removal

1. Disconnect the power supply cord.
2. Open the door and block it open.
3. Remove the one (1) screw holding the outer case
cabinet to the oven cavity front face plate (the
position is front/ center on the outer case
cabinet).
4. Remove the two (2) screws holding the hood
louver to the oven cavity.
5. Remove the hood louver from the over by
pushing the right and left tabs of the hood louver.
6. Now, the hood louver is free.
Screw
Outer case cabinet
Hood louver
Screw
Screw

Outer Case Removal

Remove the oven from the wall, and proceed as
follows:
1. Disconnect the power supply cord.
2. Open the door and block it open.
3. Remove the one (1) screw holding the outer case
cabinet to the oven cavity front face plate (the
position is front/ center on the outer case
cabinet).
4. Remove six (6) screws holding the rear stay to
the hood fan motor or the oven, and remove it.
5. Remove the six (6) screws from the rear of the
outer case cabinet.
6. Slide the outer case cabinet back about 1 inch
(3 cm) to free it from retaining clips on the cavity
face plate.
7. Disconnect the three (3) pin connector of the
power supply cord from the wiring harness and
remove the power supply cord together with the
outer case.
8. Discharge high voltage capacitor.
CAUTION
1. Disconnect oven from power supply before
removing outer case.
2. Discharge the high voltage capacitor before
touching any oven components or wiring.
4-6