Acura NSX Owner's Manual page 76

HANDLING THE UNEXPECTED
1. Park the vehicle on a firm, level and non-slippery surface, and apply the
parking brake.
2. Change the gear position to Park (P).
3. Turn the hazard warning lights and set the power mode to VEHICLE OFF
(LOCK).
4. Open the hatch
5. Loosen tool box tie downs, then remove tool box lid.
6. Take the kit out of the case.
7. Place the kit face up, on flat ground near the flat tire, and away from traffic.
Do not place the kit on its side.
Injecting Sealant and Air
1. Remove the valve cap from the tire valve stem.
140 |
2. Remove the sealant/air hose from the packaging.
3. Attach the sealant/air hose onto the tire valve stem. Screw it until it is tight.
4. Plug in the compressor to the accessory power socket.
5. Start the engine. Keep the engine running while injecting sealant and air.
6. Turn the selector switch to REPAIR (for U.S. models) or SEALANT/AIR or
PRODUIT ANTIFUITE/AIR (for Canadian models).
7. Press the inflator switch to turn on the compressor
8. After the air pressure reaches 32 psi (220 kPa), turn off the kit.
9. Unplug the power plug from the accessory power socket.
10. Unscrew the sealant/air hose from the tire valve stem. Reinstall the valve
cap.
11. Press the pressure relief button until the gauge returns to (0 kPa).
HANDLING THE UNEXPECTED
| 141