1. Manuals
  2. Brands
  3. UTStarcom Manuals
  4. Telephone
  5. FSU811
  6. User manual

UTStarcom FSU811 User Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Safety Precautions
Introduction
Thank you for purchasing the FSU811
To ensure correct usage of your phone, please read this User Guide
thoroughly
The display screens, illustrations, etc., used in this document were created
expressly for instructional purposes and may differ slightly from the
actual phone.
How to Use This Instruction Manual
In this manual, "press" means to press the key and then release; "press
and hold down" means to press the key for 2 sec or more and then release.
In this manual, "service area" refers to area that can receive signals
effectively.
Explanation of Alarm Symbols
Before using your phone, please read these "Safety Precautions"
thoroughly to ensure correct and safety usage.
The cautions included here are provided to prevent danger to persons and
property.
The following explain the degree of danger and damage that could occur
if these safety precautions are not observed correctly.
This symbol indicates that erroneous operations may directly result in
property damage or injury.
This symbol indicates that erroneous operations may result in the possibility
of property damage or injury.
This symbol indicates that erroneous operations may result in the possibility
of injury or physical damage.

Advertisement

Table of Contents
loading

Related Manuals for UTStarcom FSU811

Summary of Contents for UTStarcom FSU811

  • Page 1 Safety Precautions Introduction Thank you for purchasing the FSU811 To ensure correct usage of your phone, please read this User Guide thoroughly The display screens, illustrations, etc., used in this document were created expressly for instructional purposes and may differ slightly from the actual phone.
  • Page 2 The following symbols indicate explanations of what is to be observed. This symbol indicates a prohibited action. This symbol indicates an action that must always be performed. This symbol indicates that disassembly is prohibited. This symbol indicates that the plug of the power cord must be removed form the outlet.
  • Page 3 Handling the Phone Do not use the phone while driving. Otherwise, it may cause a traffic accident. Stop the vehicle in a safe place before using the phone. Disconnect the AC adapter and remove the battery in areas such as aircraft, hospital, etc., where such usage is forbidden to avoid influence on electronic devices and electrical medical equipment.
  • Page 4 Do not use or leave the battery close to places such as a fire, heater, etc., where temperature is high. This could result in battery leakage, overheating, cracking and fire. When the battery is recharged or stored, if there is something wrong such as generation of heat, discoloration, deformation, etc., remove the battery from the phone and do not use it any more.
  • Page 5 Do not touch the AC adapter, power cord or power outlet with wet hands. Otherwise, it may cause electrical shock. Always disconnect the power plug from the power outlet before cleaning to avoid any chance of electrical shock. Do not place heavy objects on the power cord or make modifications. Such action may result in electrical shock or fire.

  • Page 6: Table Of Contents

    Safety Precautions......................1 Getting Started ....................1-1 Check the Phone and its Accessories ..................1-1 Phone Specifications ........................1-2 Main Components ........................1-2 Provide Power to the Phone ....................... 1-5 Begin Operation ......................... 1-6 Basic Operations ....................2-1 Dialing............................2-1 One-Key Dial ..........................

  • Page 7: Getting Started

    Please check the package for the following components. If any are missing, or if the User Guide is damaged or unusable, please contact your local distributor. FSU811 Fixed Subscriber Unit (including one Ni-H battery) Power Adaptor (one) User Manual (one)

  • Page 8: Phone Specifications

    1-2 Getting Started FSU811 User Guide Phone Specifications Size Approximately 220mm×190mm×73mm (not including antenna and Microphone) Weight Approximately 0.94kg Battery Ni-MH 4.8V 1600mAH Transmitting Power Approximately 10mW Power Adaptor Input 80V--320V Output 6.5V, 680mA Battery Standby Time Approximately 48～60 hours...
  • Page 9 FSU811 User Guide Getting Started 1-3 1. Antenna 2. Power adapter socket 3. RJ-11 phone extension socket 4. Microphone 5. Liquid crystal display (LCD) 6. MENU/OK key Performs the functions indicated in the message display 7. ESC key Returns to standby mode; accesses the phone book directory when the phone is in standby.
  • Page 10 1-4 Getting Started FSU811 User Guide ： Indicate signal strength. When the phone is within a service area, the signal strength bar will be displayed. ： Displayed after picking up the receiver (off-the-hook). ： Displayed when the alarm function is enabled.

  • Page 11: Provide Power To The Phone

    FSU811 User Guide Getting Started 1-5 To decrease the phone height, press “PRESS” in the center of the stand. And at the same time press downward on the side with black rubber foot. The angle between the stand and the base of the phone can be reduced.

  • Page 12: Begin Operation

    1-6 Getting Started FSU811 User Guide 1.4.2 Battery Installation To ensure proper operation in the event of a power failure, the battery must be correctly installed. When power is cut, the battery is used; if the battery is exhausted please don’t remove it.
  • Page 13 FSU811 User Guide Getting Started 1-7 Tue. W el com e 2003- 11- 05 12: 23 M enu Nam es In case of power failure, pay attention to the battery capacity display . In case of power failure, if battery capacity is insufficient, the battery icon will flash, and an alert will sound.

  • Page 15: Basic Operations

    Basic Operations Basic Operations Menu options that correspond to a number, may be accessed by pressing the appropriate number key. You can also select an option by pressing the UP or DOWN keys to select the desired option→press the MENU/OK key. This guide primarily refers to the key-entry, selection method.
  • Page 16 2-2 Basic Operations FSU811 User Guide After dialing the number, the call timer is activated and the call duration is displayed. The time displayed here is for reference only, and should not be used as a basis for disputing charges.

  • Page 17: One-Key Dial

    FSU811 User Guide Basic Operations 2-3 After dialing the number, the call timer is activated, and the call duration is displayed. The time displayed here is for reference only, and should not be used as a basis for disputing charges After the call, press SPEAKER key to hang up, or put the MIC back to the phone.

  • Page 18: Call Hold

    2-4 Basic Operations FSU811 User Guide The call duration is displayed. The time displayed here is for reference only, and cannot be used as a basis for disputing charges. 2003- 11- 05 12: 23: 03 Tal ki ng. . .

  • Page 19: Adjust Earphone Volume During A Call

    FSU811 User Guide Basic Operations 2-5 3. After the call, A hangs up the receiver (hang-up) or presses the ESC key to disconnect with both B and C and return to the previous operation mode. Adjust Earphone Volume During a Call During a call, the earphone volume can be increased or decreased by pressing the 【Up Down】keys.

  • Page 20: Missed Call Log

    2-6 Basic Operations FSU811 User Guide As shown in the Figure 01/17, the upper right corner display indicates the last dialed number and that the phone has stored 17 dialed numbers. If there is no dialed numbers, “No Record” will be displayed.

  • Page 21: Received Call Log

    FSU811 User Guide Basic Operations 2-7 When there are missed calls, the message “Missed Call ” will be displayed, , along with their quantity. Press MENU/OK key to view the unanswered incoming calls. If there is more than one unviewed incoming calls are more than one, press UP or DOWN key to browse.
  • Page 22 2-8 Basic Operations FSU811 User Guide 2. Press 1 to display the Call Log menu. 3. Press 4 key to select “Delete Logs”. 4. Press UP key or DOWN key to select the deleting method→then press MENU/OK key ,the password entry prompt will be displayed.

  • Page 23: Phonebook

    Phonebook Phonebook Entry method Upper/lower case English letters entry and numeric entry modes are available. You can English letters and numbers. You only enter English letters when editing records in the Phonebook The characters that each key can input in each mode are listed in the table below: The character generated each time the key is pressed Lower case English letter...
  • Page 24 3-2 Phonebook FSU811 User Guide 3.1.1 Introduction to the Entry Display I nput Nam e ： 拼 拼 拼 拼 Back 1. Text display area (cursor flashes here) 2. Entry mode display area 3. Entry area 4. Character selection area 3.1.2...

  • Page 25: Store Phone Numbers

    FSU811 User Guide Phonebook 3-3 3.1.4 Delete/Modify Characters To delete a character during input, press the DEL key To modify characters, use LEFT RIGHYT keys to move the cursor in the middle of the text. The character selected by the cursor will flash. Press DEL to delete the character that is before the selected character.

  • Page 26: Search Phone Number

    3-4 Phonebook FSU811 User Guide If a record with the same name and the same number is already stored in the phone book, after pressing【MENU/OK】, the message “In Existence” will be displayed, and the phone will sound an alert tone. This duplicate record cannot be stored.

  • Page 27: Delete Search Results

    FSU811 User Guide Phonebook 3-5 4. Modify the name, then press the MENU/OK key. The modification screen of the telephone number in the record is displayed on the screen. When modifying the name, first press DEL key to delete the original name, then input the new name.

  • Page 28: Delete Phone Book Records One By One

    3-6 Phonebook FSU811 User Guide Note: If key 0 has been set to One- Key Dial, after picking up the receiver, press and hold 0 to dial the corresponding phone number. After step 2, press UP/DOWN to select the key that has been set to One-Key dial, then press MENU/OK, then press 1 to select “Change”;...

  • Page 29: Additional Functions

    The Additional Functions Additional Functions Additional Functions List Reference Operation Function Name Factory Settings Pages Your phone number MENU/OK 【 3 】【 1 】 —— Ring settings RING 6 / Low MENU/OK 【 3 】【 2 】 Date and time settings 2003/01/01 00:00 MENU/OK 【...

  • Page 30: Ring Mode

    4-2 The Additional Functions FSU811 User Guide 4.2.2 Delete Your Number 1. Press MENU/OK , then 3 ,then 1. If your number has not been entered yet, only “Own Number” will be displayed. If your number has already been entered, both “Own Number” and the number you entered will be displayed.

  • Page 31: Time Setting

    FSU811 User Guide The Additional Functions 4-3 Time setting After setting the time/date, they will be displayed in standby mode. Please enter the time correctly. Other functions (such as the alarms) refer to the time and will only function properly when it has been set.

  • Page 32: Security Settings

    4-4 The Additional Functions FSU811 User Guide Press the Right key to increase the contrast by 4, and press the Left key to decrease the contrast by 4. Press the UP key to increase the contrast by 1, and press the DOWN key decrease the contrast by 1.

  • Page 33: View The Calendar

    FSU811 User Guide The Additional Functions 4-5 View the Calendar 1. Press MENU/OK→4→1 to display the calendar menu. The cursor identifies the current date. In standby status, you can also enter the calendar screen by pressing Right key. SAT. Back 2.
  • Page 34 4-6 The Additional Functions FSU811 User Guide If the alarm has been set to “On”, the “ ” icon will be displayed. 4.9.2 Set Alarm Time 1. Press MENU/OK→4→2 to display the alarm settings menu. 2. Press 2 to select “Time”; the time entry menu is displayed.

  • Page 35: Use Of Rj11 Extension

    Connect Tel ephone or Fax m achi ne When an extension is connected, the “R” icon will flash. The FSU811 phone and its extensions may respond differently depending on use. Please refer to the following table for details. When a fax machine is connected, the speed and accuracy of the data transfer depend on the state of local network and the properties of the fax machine itself.
  • Page 36 2. Pick up The extension can continue answering incoming calls. FSU811 the call, while from FSU811 phone phone. nothing can be heard. 3. Hang up The extension can still be used to answer FSU811 the call.
  • Page 37 FSU811 phone. 3, Hang up the The off-the-hook dial tone can still be extension. heard from FSU811 phone. 4, Hang up FSU811 phone returns back to the FSU811 standby mode. phone.

  • Page 39: Wireless Internet Access(Requires Network Support)

    Note: When disconnecting the PAS modem from the FSU811 phone, use thumb and forefinger to press the tab on the connector of the PAS modem and withdraw the cable.

  • Page 41: Reference

    Reference Reference Phone Maintenance Daily cleaning Dust and dirt on the phone’s exterior can be removed with a soft cloth. Cleaning of obstinate dirt For difficult to clean areas, please use a soft wet towel with diluted cleaning agent, then wipe with a dry cloth. Do not use solvents like benzene, thinner or gas.

Table of Contents