ABB i-bus KNX Product Manual page 136

®
ABB i-bus KNX
Parameters
7.7.4.1.3 —
Dependent parameter
Standby cooling setpoint
This parameter is only visible if the device has been parameterized for cooling and the Deactivated option
has not been selected for the Basic-stage cooling parameter in the Application parameters parameter
window, and the Setpoint specification and adjustment parameter has been parameterized with the
Absolute option.
Options:
This parameter is used to set the temperature that is to apply in the Standby operating mode in the type of
operation cooling.
The temperature stated here must be lower than the temperature selected in the Comfort cooling
setpoint or Comfort heating and cooling setpoint parameter. A temperature that is at least 2 °C lower
is recommended.
The controller does not change the type of operation to reach this temperature, instead it ensures this
temperature is not dropped below on a reduction in the actual temperature.
7.7.4.1.4 —
Dependent parameter
Economy cooling setpoint
This parameter is only visible if the device has been parameterized for cooling and the Deactivated option
has not been selected for the Basic-stage cooling parameter in the Application parameters parameter
window, and the Setpoint specification and adjustment parameter has been parameterized with the
Absolute option.
Options:
This parameter is used to set the temperature that is to apply in the Economy operating mode in the type
of operation cooling.
The temperature stated here must be lower than the temperature selected in the Standby cooling
setpoint parameter. A temperature that is at least 2 °C lower is recommended.
The controller does not change the type of operation to reach this temperature, instead it ensures this
temperature is not dropped below on a reduction in the actual temperature.
134 2CDC508220D0211 Rev. A | VC/S 4.x.1
10...19...40 °C
Note
10...17...40 °C
Note