Hoover MBC 500 UV User Manual page 6

GETTING TO KNOW YOUR MATTRESS CLEANER
A. Function Button
B. Power Button
C. Dust Cup Assembly
D. Indicator Lamps
D1 - Vacuum Indicator
D2 - Agitator Indicator
D3 - UV-C Lamp Indicator
E. Dust Cup Top Cover
F. Dust Cup Lower Cover
USING YOUR MATTRESS CLEANER
Make sure all the components are correctly assembled, Extract the power cord and plug into the power supply.
The appliance will make a 3 tone sound to indicate it is ready to start.
1. Vacuum + Rotating Agitator + UV-C Lamp mode
1]
Press the on/off button [
, the appliance will automatically start up all 3 modes, Vacuum, Rotating Agitator and UV-C Lamp.
This will be indicated by 3 illuminated indicator lamps D1, D2 & D3.
At this setting, the appliance will use the UV-C radiation to kill mites, bacteria, and other harmful organisms.
The rotating agitator will disturb and loosen any dust allowing the appliance to vacuum the debris into the dust cup.
2. Vacuum + Rotating Agitator mode
1]
Press the on/off button [
, the appliance will automatically start up all 3 modes, Vacuum, Rotating Agitator and UV-C Lamp, to
switch off the UV-C lamp, press the Function Button o
This will be shown by 2 illuminated indicator lamps D1 & D2.
At this setting, the appliance will use the rotating agitator to disturb and loosen any dust allowing the appliance to vacuum the
debris into the dust cup.
3. Vacuum + UV-C Lamp mode
1]
Press the on/off button [
, the appliance will automatically start up all 3 modes, Vacuum, Rotating Agitator and UV-C Lamp, to
switch off the Rotating Agitator, press the Function Button tw
This will be shown by 2 illuminated indicator lamps D1 & D3.
At this setting, the appliance will use the UV-C radiation to kill mites, bacteria, and other harmful organisms.
The Vacuum function will vacuum the debris into the dust cup.
WARNING: In order to avoid accidental injury , the UV-C lamp WILL ONLY WORK when within a distance of 5cm from the object
being cleaned or at a working angle less than 30 degrees. If the cleaner is outside these parameters then the UV-C LAMP INDICATOR
D3 and the UV-C lamp will SWITCH OFF AUTOMATICALLY.
At any time during use, press the On/Off Button to switch the appliance off.
MATTRESS CLEANER MAINTENANCE
1. Dust Cup Cleaning
Turn off the appliance, unplug the power, press the dust cup release button and remove the dust cup assembly [2,3].
Rotate the dust cup and remove [4] Empty the contents of the dust cup and clean [5].
Unlatch the dust cup top cover [6], remove the Pre-motor filter and wash with hand warm water [7], allow to dry
thoroughly before replacing in the appliance. Rinse and wipe clean any dust build up on the Mesh [7] After cleaning,
refit the dust cup to main body [8,9].
Cleaning the Washable Filters
To maintain optimum cleaning performance regularly remove the filters and tap against the side of the bin to release
dust. The filters should be washed under hand warm water when the filter has excessive dust level. Do not use hot water
or detergents.
IMPORTANT: All bagless cleaners require regular filter cleaning. Failure to clean your filters may result in air blockage,
overheating and product failure. This may invalidate your guarantee.
*certain models only ** May vary according to model
G. Pre-Motor Filter
H. Mesh
I. Dust Cup
J. Dust Cup Release Cover
K. Power Cord
L. UV-C Lamp
M. UV-C Lamp Cover Plate
N. Rotating Agitator
O. Agitator Cover Plate
nce [1].
ice
[1].
2
GB