Advertisement
Troubleshooting
Problem
Possible causes
Bladder may be empty.
2-in-1 tank may not be seated
Reduced
properly.
spray OR
no spray
Pump may have lost prime.
Pump belt may be broken.
Brush belt or pump belt is
DirtLifter
off or broken.
PowerBrush
does not turn
ReadyTools dial may be on
wrong setting for cleaning job.
Poor tool position. (Hand held
attachments only).
Removable nozzle may not be
properly attached.
Cleaner
not picking
up solution
2-in-1 tank lid is not properly
installed.
2-in-1 tank is not properly
seated.
2-in-1 tank has picked up
maximum dirty water.
The lint screen may be clogged.
Please do
not return
this product
to the store.
Other maintenance or service not included in the manual should
be performed by an authorized service representative.
Thank you for selecting a BISSELL product.
WARNING
To reduce the risk of electric shock, push power button
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
Remedies
Push power pedal
bladder with clean hand hot
(60°F/140°C MAX) tap water and
formula.
Push power pedal
and reseat tank.
Push power pedal
turn on and press spray trigger.
Push power pedal
from outlet. Follow belt replacement
instructions on page 14.
Push power pedal
from outlet. Follow belt replacement
instructions on pages 13 and 14.
Set ReadyTools dial to either floor
cleaning or tools.
Adjust angle; apply more downward
pressure.
Make sure nozzle is on correctly by
slightly raising front of machine to
line up slots on each side of base of
machine with hooks on each side of
nozzle. Attach at base first and then
click nozzle into place. Refer to image 6
on page 9.
Re-install lid; refer to images on page 9.
2-in-1 tank must be firmly seated to
function; remove and reseat 2-in-1 tank.
Empty 2-in-1 tank and refill, refer to the
Operation section.
Clean out lint screen, refer to page 9.
www.BISSELL.com
off; refill
off; remove tank
off; after 1 minute
off and unplug
off and unplug
15
Hide quick links:
Advertisement
