Warranty And Support; Warranty Restrictions; Troubleshooting - Philips S1070 Manual

Be careful, the battery strips are
sharp.
1 Disconnect the shaver from the
mains.
2 Let the shaver operate until it
stops.
3 Undo the screws in the back of
the shaver and in the hair
chamber.
4 Remove the front panel and the
back panel.
5 Bend the 8 hooks aside and take
out the power unit.
Be careful, the hooks are sharp.
6 Take out the battery holder and
cut the battery tags with a pair of
cutting pliers.
7 Remove the rechargeable battery.

Warranty and support

If you need information or support,
please visit
www.philips.com/support or read
the international warranty leaflet.

Warranty restrictions

The shaving heads (cutters and
guards) are not covered by the terms
of the international warranty because
they are subject to wear.

Troubleshooting

This chapter summarizes the most
common problems you could
encounter with the appliance. If you
are unable to solve the problem with
the information below, visit
www.philips.com/support for a list of
frequently asked questions or
contact the Consumer Care Center in
your country.
Prob
lem
The
shaver
does not
shave as
well as it
used to.
The
shaver
does not
work
when I
press
the
on/off
button.
The
shaver
does not
work,
although
it is
connect
ed to
the
mains.
Possible
cause
The
shaving
heads
are
damaged
or worn.
Foam or
gel
residues
clog up
the
shaving
heads.
You have
not
inserted
the
shaving
heads
properly.
The
recharge
able
battery is
empty.
This
shaver is
not
designed
to be
used
directly
from the
mains.
Solution
Replace the
shaving
heads.
Rinse the
shaving unit
under a hot
tap.
Make sure
that the
projections of
the shaving
heads fit
exactly into
the recesses.
Recharge the
battery.
Recharge the
battery and
disconnect
the shaver
from the
mains.