Station Advanced Parameters - Toro Micro-Master Series User Manual

Micro-Master Touch User Guide

Station Advanced Parameters

10.4
There are five advanced setting pages for each Station Program. Page 1 sets the Irrigation Units and
the Next Program. Page 2 sets the PreStart and Cycle Delays. Page 3 selects Control Sensors to
Start, Stop and Hold the Station program. Page 4 allocates the Pump Set, Filter Bank, and Flow
Meter for the Station. Page 5 shows the current status and totals for the Station.
Units and Next Program
The Units, and Next Program screen is the first page of Advanced Station Parameters and is
displayed by pressing the icon on the Station Edit screen.
Figure 37 - Station Advanced Parameters - Page 1
Use Station 1 Config
This option sets the Station to use the same configuration units as Station 1. When enabled,
changing the parameters in this Station will change the parameters for all Stations with this option
enabled. Clicking on the tick (cross) will change the option to disabled (enabled). When enabled,
parameters that are the same as Station 1 are appended with an *.
Irrigation Units
Clicking on Irrigation Units will select the item, changing the background of the item to light blue.
Selecting the button and then clicking Edit will cycle through the available irrigation units.
Next Program
Clicking on Next Program will select the item, changing the background of the item to light blue.
Selecting the button and then clicking Edit will display the Program and Station Selection screen.
© 2014 Toro Australia Pty Ltd 59 Ver 1.2, June 2014