Table of Contents
Advertisement
2.3
Technical data
Max. del.
pressure
bar /
Type
spec. weight 1
BFT750
1.9
BFT1250
2.4
Pipe connection: Suction side
Pressure side DN40 / PN16
1) Dimensions in accordance with page 4
2) Noise emissions measured in accordance with DIN 45635 at a distance of 1 m.
The motor is surface-cooled and compliant with
DIN IEC 34 and EN 60034 (protection degree IP 55).
3 Safety instructions
When operating the pump, the safety instructions
contained in this manual, the relevant national
accident prevention regulations and any other
service and safety instructions issued by the plant
operator are to be observed.
3.1
Hazards in the event of non-compliance
with the safety instructions
Non-compliance with the safety instructions may produce
a risk to the personnel as well as to the environment and
the machine and results in a loss of any right to claim
damages.
For example, non-compliance may involve the
following hazards:
Failure of important functions of the ma-
chines/plant
Failure of specified procedures of maintenance
and repair
Exposure of people to electrical, mechanical and
chemical hazards
Endangering the environment due to hazardous
substances being released
3.2
Unauthorized modes of operation
Pump may not be used in potentially explosive
environments!
Pump and pipes are not designed to hold any
weight and may not be used as a step ladder.
BE8075
Max. del.
Dimensions
volume
H mm
l/min
600
728
800
767
DN50 / PN16
Edition 12/2016
1)
1)
Length
Weight
l mm
kg
266
61
305
72
3.3
Remaining Risk
Risk of Injury!
Risk of squeezing or crushing body parts when
installing or removing the pump exists. Proper and
secured lifting tools must be used.
Risk of burns!
The pump must have cooled down sufficiently prior
to commencing any repair, maintenance or installa-
tion.
3.4
Qualification and training of operating
personnel
The personnel responsible for operation, mainte-
nance, inspection and assembly must be adequate-
ly qualified. Scope of responsibility and supervision
of the personnel must be exactly defined by the
plant operator. If the staff does not have the neces-
sary knowledge, they must be trained and instruct-
ed, which may be performed by the machine manu-
facturer or supplier on behalf of the plant operator.
Moreover, the plant operator is to make sure that
the contents of the operating manual are fully
understood by the personnel.
Power
50 / 60 Hz
kW
2.6 / 2.94
4.0 / 4.55
Page 3 of 10
Advertisement
Table of Contents
