Configuring VLANs
Command
show vlan counters
Configuration Example for VLANs
The following example shows how to create and name a VLAN as well as how to make the state active and
administratively up:
switch# configure terminal
switch(config)# vlan 10
switch(config-vlan)# name test
switch(config-vlan)# state active
switch(config-vlan)# no shutdown
switch(config-vlan)# exit
switch(config)#
Additional References for VLANs
Related Documents
Related Topic
Command reference
NX-OS Layer 2 switching configuration
Interfaces, VLAN interfaces, IP addressing, and port channels
Multicast routing
NX-OS fundamentals
High availability
System management
Cisco Nexus 7000 Series NX-OS Layer 2 Switching Configuration Guide, Release 5.x
Configuration Example for VLANs
Purpose
Displays information on Layer 2 packets in each
VLAN.
Document Title
Cisco Nexus 7000 Series NX-OS
Layer 2 Switching Command
Reference
Cisco Nexus 7000 Series NX-OS
Layer 2 Switching Configuration
Guide
Cisco Nexus 7000 Series NX-OS
Interfaces Configuration Guide
Cisco Nexus 7000 Series NX-OS
Multicast Routing Configuration
Guide
Cisco Nexus 7000 Series NX-OS
Fundamentals Configuration Guide
Cisco Nexus 7000 Series NX-OS
High Availability and Redundancy
Guide
Cisco Nexus 7000 Series NX-OS
System Management Configuration
Guide
39