Connectors And Control Units - HELIX DSP PRO MK2 Manual

Connectors and control units

Line Input
1
signals.
Coax Input
2
Electrical input for digital stereo signals
(SPDIF format).
.
Optical Input
3
Optical input for digital stereo signals (SPDIF
format).
Clipping LED
4
This LED lights up red if one of the analog
inputs is overdriven.
7 8
Ground lift switch
7
between the grounding of the inputs and
outputs.
Control pushbutton
8
Use this button to either switch between the
setups or initiate a reset of the device.
Status LED
9
This LED indicates the operating mode of the
DSP and which setup has been chosen.
16
1
9 10 11
2 3 4 5
Highlevel Input
5
Highlevel speaker inputs for connecting a
factory radio or an aftermarket radio without
pre-amp / line outputs.
Power Input
6
Connector for the DC power supply with an
additional remote in- and output. The remote
output has to be used to switch on external
12
USB input
10
Connects the HELIX DSP PRO MK2 to your
PC.
Control Input
11
Multifunction interface for e.g. an optional
remote control or other HELIX accessory.
Line Output
12
sure that the remote output is used to turn on
these devices.
6