Cisco ASR 9000 Series Service Configuration Manual page 92

How to Configure Modular QoS Congestion Avoidance on Cisco ASR 9000 Series Routers
Command or Action
Step 5
bandwidth { bandwidth [ units ] | percent value }
or
bandwidth remaining [percent value
ratio-value
Example:
RP/0/RSP0/CPU0:router(config-pmap-c)# bandwidth
percent 30
or
RP/0/RSP0/CPU0:router(config-pmap-c)# bandwidth
remaining percent 20
Step 6
shape average {percent percentage | value
[ units ]}
Example:
RP/0/RSP0/CPU0:router(config-pmap-c)# shape
average percent 50
Step 7
exit
Example:
RP/0/RSP0/CPU0:router(config-pmap-c)# exit
Step 8
exit
Example:
RP/0/RSP0/CPU0:router(config-pmap)# exit
Step 9
interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface
TenGigE 0/2/0/0
Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide
QC-78
Configuring Modular QoS Congestion Avoidance on Cisco ASR 9000 Series Routers
Purpose
(Optional) Specifies the bandwidth allocated for a class
belonging to a policy map.
|
ratio
or
(Optional) Specifies how to allocate leftover bandwidth to
various classes.
Note One of these configurations is required for a
non-default class.
(Optional) Shapes traffic to the specified bit rate or a
percentage of the available bandwidth.
Returns the router to policy map configuration mode.
Returns the router to global configuration mode.
Enters configuration mode and configures an interface.
OL-23108-02