Overview; Safety Messages - Emerson Rosemount 3051S ERS Reference Manual

Reference Manual
00809-0100-4804, Rev CB
Section 3
Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 25
Safety messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 25
Wiring diagrams . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 26
Basic setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 26
Additional configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 30
HART menu trees . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 39
3.1

Overview

This section contains information on commissioning and tasks that should be performed on the bench
prior to installation.
Instructions for performing configuration functions are given for a handheld Field Communicator and
™
AMS
labeled "Fast Keys" for each software function below the appropriate headings.
Example software function
Fast Keys
3.2

Safety messages

Procedures and instructions in this section may require special precautions to ensure the safety of the
personnel performing the operation. Information that raises potential safety issues is indicated with a
warning symbol ( ). Refer to the following safety messages before performing an operation preceded
by this symbol.
Failure to follow these installation guidelines could result in death or serious injury.
Make sure only qualified personnel perform the installation

Explosions could result in death or serious injury.
Do not remove the transmitter covers in explosive atmospheres when the circuit is live.

Before connecting a Field Communicator in an explosive atmosphere, make sure the instruments in

the loop are installed in accordance with intrinsically safe or non-incendive field wiring practices.
Both transmitter covers must be fully engaged to meet flameproof/explosion-proof requirements.

Verify the operating atmosphere of the transmitter is consistent with the appropriate hazardous

location certifications.
Configuration
Configuration
Device Manager version 10.5. For convenience, Field Communicator Fast Key sequences are
1, 2, 3, etc.
Configuration
November 2016
25