Advertisement
Installation
Mount the DTP T DSW 4K unit in a suitable location (see the Mounting section of the DTP T DSW 4K Series User Guide for
1.
mounting options). Follow the instructions provided with the mounting kit.
Connect the USB or RS-232 connector (see
2.
commands or the Extron PCS program to configure EDID Minder, mute the video signal, mute the audio signal, adjust the
video color bit depth, or monitor the signal and HDCP status, as required (see the DTP T DSW 4K Series User Guide for more
information).
Connect the rear panel transmitter output (see
3.
pair (STP) cable.
NOTES:
•
The DTP T DSW 4K 233 can transmit video, control, and audio (if applicable) signals up to 230 feet (70 meters).
•
The DTP T DSW 4K 333 can transmit video, control, and audio (if applicable) signals up to 330 feet (100 meters).
For optimal performance, Extron highly recommends the following:
RJ-45 termination with STP cable must comply with TIA/EIA-T568B wiring standard for all connections. For more
•
information on cable wiring and termination, see the full product user guide at www.extron.com.
Use shielded twisted pair cable, 24 AWG solid conductor or better, with a minimum cable bandwidth of 400 MHz.
•
ATTENTION:
•
Do not use Extron UTP23SF-4 Enhanced Skew-Free AV UTP cable or STP201 cable.
•
N'utilisez pas le câble AV Skew-Free UTP version améliorée UTP23SF d'Extron ou le câble STP201.
Use shielded RJ-45 plugs to terminate the cable.
•
Overall transmission distance capabilities vary depending on the number of patches used. If possible, limit the number of
•
patches to 2 total.
If RJ-45 patches must be used in the system, Extron recommends shielded CAT 6 (or better) patches.
•
Connect control devices.
4.
Connect contact closure devices or Extron "Show Me" cables to the Contact In 4-pole captive screw connector (see
a.
on the previous page).
Connect tally devices or Extron "Show Me" cables to the Tally Out 4-pole captive screw connector (see
b.
previous page).
For serial RS-232 control, connect a host device to the RS-232 3-pole captive screw connector (see
c.
page) or the 3-pole captive screw connector (see
For control or configuration through USB, connect a host device to the front panel USB mini-B port (see
d.
Connect and power on related devices to the switcher and compatible receivers.
5.
At the power outlet, connect the power supply to power on the unit (see the DTP T DSW 4K Series User Guide for information
6.
on power connector wiring and remote power).
on the previous page) to a PC for configuration and maintenance. Use SIS
G
on the previous page) to a rear panel receiver input using shielded twisted
D
G
on the previous page).
G
on the
G
on the previous
F
on page 1).
B
3
Advertisement
