Manual Cutting Control - Pfaff 3519-5/01 Instruction Manual

Adjustment
13

Manual cutting control

.06.06
● Fit the needle plate.
● Manually move the thread catcher 1 to its front turning point.
● Pull a double-up length of thread and hook it in the thread catcher cutout.
● Carry out the cutting operation manually.
● If the threads are not cut according to the rule, align the thread catcher 1 (screws 2) to
● Move the stop 4 until it abuts the thread catcher 1 and tighten the screws 5.
● Chapter 13.06.03 Checking and if necessary adjusting the lateral alignment of the
82
Rule
Two threads must be cut cleanly on both the left and right in the thread catcher cutout 1.
4
3
Fig. 13 - 15
the knife 3 accordingly.
thread catcher.
2
1
2
5
5
1