Changing Lan Settings - Belkin F5D9630-4 User Manual

Using the Web-Based Advanced User Interface Using the Web-Based Advanced User Interface

Changing LAN Settings

All settings for the internal LAN setup of the Router can be viewed and
changed here.
1. IP Address
The "IP address" is the internal IP address of the Router. The default
IP address is "192.168.2.1". To access the advanced setup interface,
type this IP address into the address bar of your browser. This address
can be changed if needed. To change the IP address, type in the new
IP address and click "Apply Changes". The IP address you choose
should be a non-routable IP. Examples of a non-routable IP are:
192.168.x.x (where x is anything between 0 and 255)
10.x.x.x (where x is anything between 0 and 255)
2. Subnet Mask
There is no need to change the subnet mask. This is a unique,
advanced feature of your Belkin Router. It is possible to change the
subnet mask if necessary; however, do NOT make changes to the
subnet mask unless you have a specific reason to do so. The default
setting is "255.255.255.0".
3. DHCP Server
The DHCP server function makes setting up a network very easy
by assigning IP addresses to each computer on the network
automatically. The default setting is "On". The DHCP server can be
turned OFF if necessary; however, in order to do so you must manually
set a static IP address for each computer on your network. To turn off
the DHCP server, select "Off" and click "Apply Changes".
34 34