Table of Contents
Advertisement
DPN-144DG GPON ONT Dual Band Wireless AC1200
VoIP Gateway with 1 GPON Port, 4 10/100/1000Base-T
Ports, 2 FXS Ports, and 1 USB Port
User Manual
Parameter
Use multicast for
service data exchange
Multicast TTL
Multicast group
address
Maximum time of
storing data on
adjacent clients
Minimum level of
connection quality
Dead zone
After specifying the needed parameters, click the APPLY button.
To disable the function of smart adjustment of Wi-Fi clients, move the Enable switch to the left.
Move the switch to the right in order to use multicast traffic for
service data exchange between access points (routers, gateways).
This setting is needed if the devices which support the smart
adjustment function are located in different subnets. If the switch is
moved to the right, the Multicast Settings section is displayed on
the page.
If the switch is moved to the left, broadcast traffic is used for service
data exchange.
Multicast Settings
Specify the TTL (Time to live) parameter value. The recommended
value is 4.
Specify the address of the multicast group (from the subnet
239.255.0.0/16).
2.4 GHz / 5 GHz
The maximum time period (in seconds) during which the access
point (router, gateway) stores data on the signal strength of the client
located on its coverage area.
The threshold value of the signal strength upon which the access
point (router, gateway) starts scanning other devices.
This parameter is used for calculation of the signal strength upon
which the smart adjustment function goes off. If the signal strength
provided by the device is less than the sum of the Minimum level
of connection quality field value and the Dead zone field
value, then the client disconnects from the access point (router,
gateway) and connects to another device. You can specify the values
from -50% to +50%.
Page 113 of 217
Configuring via Web-based Interface
Description
Advertisement
Table of Contents
