Cleaning And Maintenance; Cleaning Chart; Removing The Drawer; Replacing The Drawer - Thermador WD30W Use And Care Manual

Cleaning and Maintenance

With good care and cleaning, your appliance will retain
its appearance and remain fully functional for a long time
to come. How to correctly care for and clean your
warming drawer or storage drawer is detailed below.

Cleaning Chart

Part Recommendations
Drawer Interior Use dish detergent. Wash, rinse well
(polished and dry. For hard water spots or
stainless steel) scale, use white vinegar. Apply with a
sponge or cloth, rinse and dry.
Painted Surfaces Use hot soapy water or mild cleaners
such as Fantastik
Wash, rinse well and dry.
Do not use abrasive cleaning agents,
steel wool pads and oven cleaners.
Drawer Exterior Always wipe or rub in the direction of
Frame (brushed the grain. Clean with a soapy sponge,
stainless steel) then rinse and dry, or wipe with
Fantastik
on a paper towel. Protect and polish
with Stainless Steel Magic
cloth. Remove water spots with a
cloth dampened with white vinegar.
Use Bar Keeper's Friend
heat discoloration.
Control Panel Clean with hot soapy water or apply
Fantastik
(warming
clean sponge or paper towel and
drawer only)
wipe clean.
Do not use abrasive cleaners and
scrubbing pads.
10
or Formula 409
®
or Formula 409 sprayed
® ®
and a soft
®
to remove
®
or Formula 409 to a
® ®

Removing the Drawer

CAUTION
9
To prevent burns, do not remove the drawer while
hot. Be sure the drawer is empty before removing.
.
®
For WD30W warming drawer, pull drawer to fully open
1.
position.
For WD30WC warming drawer and SD30WC and
2.
SDS30WC storage drawers, slightly push drawer to
the fully open position.
Press down on right drawer clip.
3.
Lift up on left drawer clip.
4.
Firmly pull the drawer straight out. Retract the cabinet
5.
rails while the drawer is removed.
If additional issues remain at this point, contact Customer
Service.

Replacing the Drawer

Be sure cabinet rails are pushed inside the cabinet.
1.
Align the drawer rails with the cabinet rails.
2.
Firmly push the drawer straight into the cabinet until
3.
the drawer clicks in to place.
Open and close the drawer to test operation.
4.
Note: If the drawer will not close, verify the rail clips
are properly positioned.